Channel Plus Speaker H424 User Manual

ChannelPlus Multi-switch  
OpenHousetm modules attach from the top  
The H424 satellite multi-switch connects up to four  
1
satellite receivers to a dual LNB dish. The  
multi-switch locks one LNB to receive  
right hand polarized signals and  
the other LNB to receive  
1) Hook from the top  
2) Swing into place  
3) Push button to lock  
left hand polarized  
signals. The individual  
3
Telephone Master Hub (4 lines  
x
6
phones)  
ChannelPlus model H616  
satellite receivers may  
From  
Telco  
Expansion  
Ports  
Telephones  
televisions)  
H838HHR  
8
R
T
RJ31X  
x
4
3
2
1
R
T
nputs  
i
3
(
select any satellite  
channel. The multi-  
switch will automatically  
connect the receivers to  
the correct LNB.  
R
T
Hub  
odel  
m
Out  
R
T
Video  
ChannelPlus  
2
Satellite and antenna distribution  
Typical installation  
Antenna  
or CATV  
Dual LNB dish is required  
Video hub  
(H838HHR shown)  
High Headroom Amp w/IR Engine  
LNB-A  
13V  
LNB-B  
18V  
dish  
LNB-A  
13V  
LNB-B  
18V  
B
+Pwr  
dish  
Televisions  
CATV  
nt  
Modulators  
satellite receivers  
A
satellite receivers  
The highest performance method  
of distributing satellite and  
antenna (or CATV) signals is to  
keep them separate. Run a second  
coax cable to each room that will  
have a satellite receiver.  
Up to four  
satellite receivers  
Expanding the outputs  
Satellite and antenna distribution  
using diplexers  
LNB-A  
13V  
LNB-B  
18V  
dish  
Video hub  
(H838HHR shown)  
High Headroom Amp w/IR Engine  
LNB-A  
13V  
LNB-B  
18V  
satellite receivers  
dish  
B
+Pwr  
Televisions  
CATV  
Ant  
Modulators  
satellite receivers  
A
LNB-A  
13V  
LNB-B  
18V  
LNB-A  
13V  
LNB-B  
18V  
dish  
dish  
Diplexer  
Diplexers allow you to combine satellite  
and antenna (or CATV) signals on a  
single coax. Combining these signals  
sometimes creates new problems: The  
diplexer will reduce the signal strengths,  
increasing the chance of noisy pictures.  
Coupling the two also invites  
satellite receivers  
satellite receivers  
Single coax  
Diplexer  
interference. We recommend only  
using diplexers when you cannot run a  
second coax.  
Adding a second multi-switch expands the system to six receivers. Adding  
a third multi-switch allows the use of up to eight satellite receivers. Do not  
cascade multi-switches more than 2 ‘layers’ deep.  
 

Belkin Network Card F5D5050 User Manual
Black Decker Lawn Sweeper LSWV36 User Manual
Bosch Power Tools Sander GP712VS User Manual
Bose Speaker System 149393 User Manual
Campbell Hausfeld Cooktop SN318K00 User Manual
Cardinal Gates Safety Gate MG25 User Manual
Casablanca Fan Company Outdoor Ceiling Fan 55027 User Manual
Chariot Carriers Baby Carrier 51100452 User Manual
Chicago Electric Portable Generator 66619 User Manual
Chicago Pneumatic Cordless Drill CP 8730 User Manual