Belkin Printer Accessories F5U002 User Manual

USB Parallel Printer  
Adapter  
Packing Checklist  
(1) One Belkin USB Parallel Printer Adapter with  
connectors for USB type A port and a Centronics  
36 male port  
Floppy Disk Installation Software  
User Guide  
Please read this manual thoroughly and follow the  
procedures to prevent any damage to the USB Parallel  
Printer Adapter and/or to the connected devices.  
F5U002  
Introduction  
The Belkin Components USB Parallel Printer Adapter will allow any Windows® 98 PC equipped with a USB port to print  
to any parallel printer. USB allows the connection of up to 127 devices to a single PC. Simply plug the USB connector into  
the computer USB port and the Centronics connector into the appropriate printer. This installation procedure automatically  
detects the adapter and sets up your system to use your printer device every time your computer is started.  
The Belkin USB Parallel Printer Adapter is also supported by a one year warranty and free technical support should you  
have any questions about installing or using the USB Parallel Printer Adapter.  
Product Features  
Requirements  
Hardware  
IBM 486 compatible processor or higher  
USB port  
Operating Systems Requirements  
This software runs in Windows® 95, and Windows® 98 and Windows® 98SE. Windows® 95 must be OSR2.1 version  
1214 which contains the USB supplement.  
1
 
5. To complete the uninstall, you will be asked to  
reboot your computer. Click Yes to reboot your  
computer now. Once you reboot you will not have to  
reboot where indicated in Step 2 of the installation  
instructions.  
4. If the USB Parallel Printer Adapter is not plugged in, you  
will see the message under the "Print to the following port"  
box in Figure 3. Plug the Belkin USB Parallel Printer  
Adapter into the printer as show in Step 4 of New  
Installation.  
6. Proceed with the installation instructions beginning  
with Step 3 to reinstall the Parallel Printer Adapter.  
Figure 3  
TROUBLESHOOTTING  
1. To install the Parallel Printer Adapter you must  
have all the USB components installed.  
a) First ensure that the USB interface for your  
computer's CMOS has been enabled. Check your  
computer's user manual on how to configure  
your CMOS.  
b) Second, open My Computer, open the Control  
Panel folder and then open the System icon. Click  
the Device Manager tab. The last device you see  
should say Universal Serial Bus controller. If  
not, you will need to install it from your  
Windows® 98 CD.  
2. If you already have the USB Parallel Printer  
Adapter installed and you are updating to  
Windows® 98, then return to the section entitled  
Overwrite Previous Installation,  
3. If the Device ID cannot be retrieved from the printer  
as shown in Figure 2, reinstall your printer with the  
printer manufacturer's software on the parallel  
port(LPT1) like a normal printer installation.  
5. If the error message appears in Figure 4, simply  
update your Windows" operating system to  
Windows® 98.  
Figure 4  
Figure 2  
6. If you are still unable to print, the drivers for your printer  
may not support bi-directional printing through a USB to  
parallel adapter. For instructions on  
disabling bi-directional printing, please visit our web site at  
3
 
Software Components  
CE Declaration of Conformity  
The software necessary for standard PnP installation and  
operation of the USB Parallel Printer Adapter consist of the  
following:  
We, Belkin Components, declare under our sole  
responsibility that the F5UO02, to which this declaration  
relates, is in conformity with EUROPEAN STANDARD  
EN 55022/Al Class B, and EN 50082-1 (IEC 801-2, IEC  
801-3, IEC 801-4).  
1. Class Installer  
BPPU2PAR.SYS  
FU5002.INI  
ETKPRCI.DLL  
BPPPMON.DLL  
F5U002A.INF  
F5U002.INF  
2. VVDM device driver  
3. Port monitor installer  
4. Port monitor  
THE WARRANTY AND REMEDIES SET FORTH  
ABOVE ARE EXCLUSIVE AND IN LIEU OF ALL  
OTHERS, WHETHER ORAL OR WRITTEN, EXPRESS  
OR IMPLIED. BELKIN SPECIFICALLY DISCLAIMS  
ANY AND ALL IMPLIED WARRANTIES, INCLUDING,  
WITHOUT LIMITATION, WARRANTIES OF  
MERCHANTABILITY AND FITNESS FOR A  
PARTICULAR PURPOSE.  
5. Install file  
6. Uninstall Program  
BPPUNIN1.EXE  
FCC/CE Statement  
This equipment has been tested and found to comply with  
the limits for a Class A & B digital device, pursuant to  
part 15 of the FCC Rules. These limits are designed to  
provide reasonable protection against harmful interference  
in a residential installation. This equipment generates,  
uses and can radiate radio frequency energy and, if not  
installed and used in accordance with the instructions,  
may cause harmful interference to radio communications.  
However, there is no guarantee that interference will not  
occur in a particular installation. If this equipment does  
cause harmful interference to radio or television reception,  
which can be determined by turning the equipment off  
and on, the user is encouraged to try to correct the  
No Belkin dealer, agent, or employee is authorized to make  
any modification, extension, or addition to this warranty.  
BELKIN IS NOT RESPONSIBLE FOR SPECIAL,  
INCJDENTAL, OR CONSEQUENTIAL DAMAGES  
RESULTING FROM ANY BREACH OF WARRANTY,  
OR UNDER ANY OTHER LEGAL THEORY,  
INCLUDING BUT NOT LIMITED TO LOST PROFIT,  
DOWNTIME, GOODWILL, DAMAGE TO OR  
REPROGRAMMING, OR REPRODUCING ANY  
PROGRAM OR DATA STORED IN OR USED WITH  
BELKIN PRODUCTS.  
interference by one or more of the following measures:  
Some states do not allow the exclusion or limitation of  
incidental or consequential damages or exclusions of implied  
warranties, so the above limitations of exclusions may not  
apply to you. This warranty gives you specific legal rights,  
and you may also have other rights that vary from state to  
state.  
•Reorient or relocate the adapter.  
•Increase separation between the hub, computer,  
monitor and printer.  
*Connect the equipment into an outlet or a circuit  
different from the one that it is currently connected.  
•Consult dealer or technical support for help.  
Belkin Components Product Warranty  
Belkin Components warrants this product against defects  
in materials and workmanship for the life of the product.  
If a defect is discovered, Belkin will, at its option, repair  
or replace the product at no charge, provided it is returned  
during the warranty period, with transportation charges  
prepaid, to the authorized Belkin dealer from whom you  
purchased the product. Proof of purchase  
501 West Walnut Street - Compton - CA - 90220-5221  
800.223.5546* 310.898.1100 - FAX 310.898.1111 *  
may be required.  
Belkin Components, Ltd.  
This warranty does not apply if accident, abuse, misuse,  
or misapplication has damaged the product; if the product  
has been modified without the permission of Belkin; or if  
any Belkin serial number has been removed or defaced.  
Clarke Road - Mount Farm - Bletchley, Milton Keynes * MKI 1LG  
Phone +44 (0) 1908367178 * FAX +44 (0) 1908366564  
©1999 Belkin Components. All Rights Reserved. All Trade Names Are  
Registered Trademarks Of Respective Manufacturers Listed.  
P72670  
4
 

Blaupunkt Car Stereo System DX R70 User Manual
Bose Stereo System AM293692 User Manual
Boston Acoustics Speaker System Shelf Stereo System User Manual
Braun Bathroom Aids C 31S User Manual
Braun Bathroom Aids LS 30 User Manual
Bush Hog Lawn Mower 665H User Manual
Califone DJ Equipment PA310 User Manual
Campbell Hausfeld Nail Gun IN180300AV User Manual
Casio Cell Phone Brigade User Manual
Casio Watch 2168 User Manual